Important Information; Certified Installation - Raymarine CP370 Installation Instructions Manual

Chapter 1: Important information

Certified Installation

Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for enhanced product warranty benefits.
Contact your Raymarine dealer for further details,
and refer to the separate warranty document packed
with your product.
Warning: Product installation and
operation
This product must be installed and
operated in accordance with the
instructions provided. Failure to do so
could result in personal injury, damage
to your vessel and/or poor product
performance.
Warning: Potential ignition source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room
or near fuel tanks).
Warning: Product grounding
Before applying power to this product,
ensure it has been correctly grounded, in
accordance with the instructions provided.
Warning: Positive ground systems
Do not connect this unit to a system which
has positive grounding.
Warning: Power supply voltage
Connecting this product to a voltage
supply greater than the specified
maximum rating may cause permanent
damage to the unit. Refer to the Technical
specification section for voltage rating.
Warning: Switch off power supply
Ensure the vessel's power supply is
switched OFF before starting to install this
product. Do NOT connect or disconnect
equipment with the power switched on,
unless instructed in this document.
Caution: Power supply protection
When installing this product ensure the
power source is adequately protected
by means of a suitably-rated fuse or
automatic circuit breaker.

Important information

Warning: High voltage
This product contains high voltage.
Adjustments require specialized service
procedures and tools only available to
qualified service technicians. There are
no user serviceable parts or adjustments.
The operator should never remove the
cover or attempt to service the product.
Warning: Transducer cables
Do not remove the transducer cable whilst
the product is powered on, doing so can
cause sparks. If the transducer cable is
accidently removed whilst the product is
powered on, switch the product's power
off, replace the cable and then switch the
power back on.
Warning: Sonar operation
• NEVER operate the sonar with the
vessel out of the water.
• NEVER touch the transducer face when
the sonar is powered on.
• SWITCH OFF the sonar if divers are
likely to be within 7.6 m (25 ft) of the
transducer.
Caution: Do not cut transducer
cables
• Cutting the transducer cable severely
reduces sonar performance. If the
cable is cut, it must be replaced, it
cannot be repaired.
• Cutting the transducer cable will
void the warranty and invalidate the
European CE mark.
Caution: Service and maintenance
This product contains no user serviceable
components. Please refer all maintenance
and repair to authorized Raymarine
dealers. Unauthorized repair may affect
your warranty.
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this
product meets the stated IPX standard (refer to the
product's Technical Specification), water intrusion
and subsequent equipment failure may occur if the
product is subjected to commercial high-pressure
washing. Raymarine will not warrant products
subjected to high-pressure washing.