Waterproofness/Dustproofness - NTT docomo Rakuraku 7 Instruction Manual

18
Waterproofness/Dust-
proofness
F-09B is provided with the following
waterproofness by firmly closing the external
connection jack cap, installing the back cover and
locking the cover.
・
IPX5 (Former JIS protection code 5)
*3
・
IPX8 that is a higher standard than IPX7
(former JIS protection code 7)
Also, F-09B is dustproof to IP5X (former JIS
*4
protection code 5)
jack cap is strictly closed as well as the back cover
is mounted and locked.
*1 Code IPX5 means that a phone keeps functioning
after directly applying a jet flow of 12.5 L/min. for at
least 3 minutes from a distance of 2.5-3 m on a
rotating turntable.
*2 Code IPX7 means that a phone keeps functioning
after it is slowly submerged to depth of 1 m in static
tap water at room temperature, left there for 30
minutes and then taken out.
*3 Code IPX8 means that it provides waterproofness
of which exceeds of IPX7 standard.
*4 Code IP5X means that a device is protected against
the ingress of dust specific to dustproof test (25
μm or smaller in diameter), so that the ingress will
not interfere with predefined operation and safety
of the device.
F-09B provides the following waterproof
performances of IPX8.
･
F-09B keeps functioning after it is slowly
submerged to depth of 1.5 m in static tap water
at room temperature, left there for 30 minutes
and then taken out.
･
The mobile phone keeps shooting still images
or moving pictures in 30 minutes in static tap
water at room temperature.
*1
*2
if the external connection
What you can do with waterproofness and
dustproofness of F-09B
・
You can talk or watch 1Seg programs without using an
umbrella in the rain (for rainfall of 20 mm or less per
hour).
- When your hands or FOMA terminal are wet, avoid
installing/removing the back cover or opening/
closing the external connection jack cap.
・
You can also shoot still images and moving pictures in
the pool depth of 1.5 m.
- Do not perform operations underwater except
shooting still images or moving pictures.
- If you put the terminal in water of swimming pool, be
sure to have it within 30 minutes.
- If FOMA terminal gets wet with water from the
swimming pool, wash it as predefined (→p.20).
・
You can use FOMA terminal in a bathroom.
- Do not put the terminal in the bathtub. Do not use the
terminal in hot water. May cause malfunction.
- Never put FOMA terminal in hot spring water or
water containing soap, detergent or bath powder.
To ensure waterproofness/
dustproofness
To avoid water and dust ingress, be sure to observe the
following points.
・
Do not throw any liquid other than room-temperature
tap water on FOMA terminal, or soak it in such liquid.
・
Open/close the external connection jack cap as
described below.
<Opening the external connection jack cap>
Place your finger at groove on the back cover side to
open the cap.
Groove on the back
cover side
<Closing the external connection jack cap>
Close with the tab for the hinge at the rear side of the
cap fitted into the concave of the terminal. Make sure
that the cap is completely closed without slack.
Tab on the hinge side