Waterproofness/Dustproofness - NTT docomo F-05D Instruction Manual

Waterproofness/
Dustproofness
F-05D provides waterproofness of IPX5
*3
dustproofness of IP5X
connection jack/stereo earphone jack cap and steadily
installing the back cover.
*1 IPX5 means that a phone keeps functioning after applying a
jet flow of 12.5 L/min. from every direction from a distance of
approximately 3 m for at least 3 minutes using water nozzle in
6.3 mm inner diameter.
*2 For F-05D, IPX8 means that a phone keeps functioning after
F-05D is slowly submerged to depth of 1.5 m in static tap
water at room temperature, left there for 30 minutes and then
taken out. (Camera function cannot be used under water.)
*3 IP5X means a protection degree that a phone keeps
functioning and safety after it is placed in a device with dust in
diameter 75μ or less for 8 hours, agitated and then taken out.
❖
What you can do with waterproofness
of F-05D
・
You can talk and watch 1Seg without an umbrella in the
rain (for rainfall of 20 mm or less per hour).
- When your hands or the terminal are wet, avoid
installing/removing the back cover or opening/closing
the external connection jack/stereo earphone jack cap.
・
The terminal can be submerged into a pool which has a
depth of 1.5 m.
- Do not operate under water.
- If you put the terminal in water of swimming pool, be
sure to have it within 30 minutes.
- If the terminal gets wet with water from the swimming
pool, wash it in following procedure(→P20).
・
You can use the terminal in a bathroom.
- Do not put the terminal in the bathtub. Do not use the
terminal in hot water. May cause malfunction.
- Never put the terminal in hot spring water or water
containing soap, detergent or bath powder.
*1 *2
, IPX8
with firmly closing the external
◆ To ensure waterproofness/
dustproofness
To avoid water/dust ingress, be sure to observe the
following points.
・
Do not throw any liquid other than room-temperature
and
tap water on the terminal, or soak it in such liquid.
・
When using the external connection jack, HDMI jack or
stereo earphone jack, pull the cap up with your finger by
the groove as shown in the illustration.
Groove
After using the external connection jack, HDMI jack or
stereo earphone jack, close the cap as the direction
shown in the illustration, and make sure that the cap is
completely closed without slack by pushing the tab in.
・ For installing the back cover, see de in "■ Attaching"
of "Attaching/Removing battery pack".→P26
18
Contents/Precautions