Programming Channel Names - Icom IC-R2500 Instruction Manual

5
MEMORY OPERATION

■ Programming channel names

Each memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indicated
independently by channel. Names can be a maximum of 6
characters— see the table on next page for available charac-
ters.
q Select the desired memory channel to be programmed.
➥ Push [VFO/MR•S.MW] to select memory mode, then ro-
tate [DIAL] to select the desired memory channel.
wPush and hold [VFO/MR•S.MW] for 1 sec. to enter select
memory write mode.
• "!" indicator and the memory channel number blink.
[EXAMPLE]: Programming "CLUB" into memory channel 12.
Select
VFO/MR
memory channel
S.MW
Rotate
21
Push VFO/MR for 1 sec.
S.MW
Repeat the
previous
steps.
e Push [SET•SKIP] several times to select the memory
name programming condition, "m nAmE."
• Frequency readouts disappear and a cursor blinks.
r Rotate [DIAL] to select the desired character.
• The selected character blinks.
t Push [ATT•PRIO] to move the cursor to the right.
• Repeat pushing [ATT•PRIO] to return to the first digit.
y Repeat steps r and t until the desired channel names
are displayed.
u Push and hold [VFO/MR•S.MW] for 1 sec. to program the
name and exit select memory write mode.
SET
Push twice
SKIP
Push
"
"
Beep
"
Beep
"
VFO/MR for 1 sec.
S.MW
Beep
"