Changing Default Settings - Epson LX–350 User Manual

This setting is available only in the IBM PPDS emulation mode. When auto carriage return is on, each line feed (LF) code or
ESC J code is accompanied by a carriage return code. This moves the print position to the beginning of the next line.
Manual feed wait time
This sets the amount of wait time between the time paper is inserted into the paper guide and when it is fed. If the paper
feeds before you can adjust its position to your satisfaction, you can increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs or a panel operation is made. (See
printer errors.) If you do not want the printer to beep, turn off this setting.
Low-noise mode
When you choose On, the noise is reduced, but the printing speed is slower.
IBM character table
This setting is available only in IBM PPDS emulation mode. When you select Table1, hex codes 80H to 90H of the character
tables are used for the control codes. When you select Table 2, hex codes 80H to 90H are used for characters.
Power off timer
When a time is set, the printer automatically turns off after the set time has passed while in standby status. To turn on the
printer again, turn off the power switch and then turn it back on.

Changing default settings

The following table shows the basic function of each button in the default setting mode.
Button
Menu (LF/FF and Load/Eject) buttons
Item button
Item button
Set button
Follow these steps to enter the default-setting mode and change the printer's default settings:
Note:
Before entering the default-setting mode, you need to load A4 or letter size single-sheet paper or
continuous paper that is at least 297 mm (11 inches) long and 210 mm (8.27 inches) wide.
If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed
sheet.
If you turn off the printer prior to exiting default-setting mode, any changes you may have made are
canceled and not saved.
Make sure paper is loaded.
Press the Menu (LF/FF and Load/Eject) buttons until the printer beep once.
Using the Error Indicators
Basic function
Enters or exits the default setting mode.
Selects the next menu parameter.
Selects the previous menu parameter.
Changes the value in the selected menu.
for more information on
Top