Table of Contents
Advertisement
The ID and Protocol numbers of the Dome Camera are set with a 10-bit and 6-bit dip switch respectively
using binary system. For switch configuration details, please refer to
2.3 Communication Switch Setting
The Dome Camera's communication switches are specified in the table below.
Communication Switch
RS-485 is the interface that communicates to the Dome Camera and its control device; for this reason, the
RS-485 setup of the Dome Camera and the control device must be the same. The RS-485 default setting is
half-duplex (see the following diagram). Please do not change the default setting without qualified specialists or
a supplier's notice. The SW3 and SW4 are used for termination and Line Lock adjustment, respectively. To
use the termination, apply the switch to the last PTZ camera as shown in the figure below. Use the SW5 to
restore the camera to the factory default status. Once firmware upgrade is complete, reset the SW6.
Appendix B: Switch Settings Index
SW 1
RS-485 Setting
SW 2
SW 3
Termination
SW 4
Line Lock
SW 5
Factory Default Reset
SW 6
Camera Upgrade
8
Table.
GVI Security
Advertisement
Table of Contents
