Events - AMX ACV-2100 ACENDO VIBE Instruction Manual

Events

Acendo Vibe will send event messages when asynchronous events, i.e. occurrences not related to a received command,
happen.
Note that the Acendo Vibe supports the Command Protocol on both its USB and RS-232 interfaces. However, events are
only reported on the RS-232 interface.
The table below shows the possible events to be reported with the EVENT message:
Event <Event Name> <Event Data>
Event Name
boot_complete
bt_conn
bt_dis
bt_remote_conn
bt_ remote_dis
bt_inactive
bt_oor
hdmi_conn
hdmi_dis
mic_mute
mic_unmute
occupancy_det
spkr_mute
spkr_unmute
src_change_audio
usb_conn
usb_dis
vacancy_det
vol_change
Acendo Vibe Conferencing Soundbars - User Guide
Event Data
<setting> = "aux", "bluetooth", "hdmi", "optical" or "usb"
<level> = 0..100
Serial Commands
Description
Booting complete
Bluetooth connected
Bluetooth disconnected
Remote control connected
Remote control disconnected
Bluetooth audio inactive for 30 minutes
Bluetooth out-of-range for 5 minutes
Connection on external HDMI input
Disconnection on external HDMI input
Microphone muted
Microphone unmuted
Occupancy detected
Speakers muted
Speakers unmuted
Audio source changed
Connection on external USB
Disconnect on external USB
No occupancy detected for N seconds
Volume changed
38