AMX ACV-2100 ACENDO VIBE Instruction Manual page 36

Serial Commands - ACV-5100 (Cont.)
Command
get /occupancy/internal/state
set /ringleds/color
set /ringleds/state
get /trigger/hdmiconn/action
set /trigger/hdmiconn/action
get /trigger/hdmiconn/delay
set /trigger/hdmiconn/delay
get /trigger/hdmidis/action
set /trigger/hdmidis/action
get /trigger/hdmidis/delay
set /trigger/hdmidis/delay
get /trigger/occupancy/action
set /trigger/occupancy/action
get /trigger/occupancy/delay
Acendo Vibe Conferencing Soundbars - User Guide
Description
Get the state of the internal occupancy sensor (mic's).
Returns:
@get /occupancy/internal/state <state>
Where: <state> = "none", "occupied" or "vacant"
Set the color of the ring (meeting status) LEDs.
Syntax:
set /ringleds/color <color>
Where: <color> = R:G:B
where R, G, and B are 0..255.
Note: R=G=B=0 turns LEDs off
Set the state of the ring (meeting status) LEDs.
Syntax:
set /ringleds/state <state>
Where: <state> = "off", "on" or "pulsing"
Get display action for the HDMI connect trigger event.
Returns:
@get /trigger/hdmiconn/action <display-action>
Where: <display-action> = "none" or "on"
Configure display action for the HDMI connect trigger event.
Syntax:
set /trigger/hdmiconn/action <display-action>
Where: <display-action> = "none" or "on"
Get delay time for the HDMI connect trigger event.
Returns:
@get /trigger/hdmiconn/delay <delay>
Where: <delay> = 0..300 (seconds)
Configure delay time for the HDMI connect trigger event.
Syntax:
set /trigger/hdmiconn/delay <delay>
Where: <delay> = 0..300 (seconds)
Get display action for the HDMI disconnect trigger event.
Returns:
@get /trigger/hdmidis/action <display-action>
Where: <display-action> = "none" or "off"
Configure display action for the HDMI disconnect trigger event.
Syntax:
set /trigger/hdmidis/action <display-action>
Where: <display-action> = "none" or "off"
Get delay time for the HDMI disconnect trigger event.
Returns:
@get /trigger/hdmidis/delay <delay>
Where: <delay> = 0..300 (seconds)
Configure delay time for the HDMI disconnect trigger event.
Syntax:
set /trigger/hdmidis/delay <delay>
Where: <delay> = 0..300 (seconds)
Get display action for the occupancy detect trigger event.
Returns:
@get /trigger/occupancy/action <display-action>
Where: <display-action> = "none" or "on"
Configure display action for the occupancy detect trigger event.
Syntax:
set /trigger/occupancy/action <display-action>
Where: <display-action> = "none" or "on"
Get delay time for the occupancy detect trigger event.
Returns:
@get /trigger/occupancy/delay <delay>
Where: <delay> = 0..300 (seconds)
Serial Commands
36