Connections; Acv-5100 Connectors - AMX ACV-2100 ACENDO VIBE Instruction Manual

Connections

All connectors are located within the connector bay (rear panel).
For surface installations, place the unit face-down and open the connector bay door to manage

cables/connectors.
For wall-mounted installations, simply rotate the Acendo Vibe unit down and away from the wall to access the

connector bay.
There are two sets of connectors on the inner side panels of the connector bay. Each connector is labeled on the elastic
cable straps. Run each cable through the cable pass-thru in the bracket/door and under the cable straps.

ACV-5100 Connectors

The connectors on the ACV-5100 are shown in FIG. 11: .
RS-232 (3-pin captive wire - for Serial communication)
FIG. 11
ACV-5100 connector bay
ACV-5100 Connections
DC POWER
OPTICAL AUDIO
AUX OUT
AUX IN
HDMI OUT
HDMI IN
USB
RS-232
MOTION
(future firmware upgrade)
Run each cable through the cable pass-thru in the bracket/door and under the cable strap
Acendo Vibe Conferencing Soundbars - User Guide
DC Power input
Optical audio input
cable strap
Analog audio output
Analog audio input
MOTION (3-pin captive wire)
(future firmware upgrade)
HDMI Input (from source device)
Connect the included 15V
with the ACV-5100.
Use this TOSLINK connector to receive Optical Stereo Input from an audio source device.
Use this 1/8" mini-stereo connector to send analog stereo sound from the Acendo Vibe to an auxiliary
device.
Use this 1/8" mini-stereo connector to receive analog stereo sound from an analog audio source device.
(Type A) Connect to an HDMI input on a display device.
(Type A) Connect to an HDMI output from a source device, such as a laptop or Acendo Core.
Use the USB 2.0 Type-B port to connect a PC/laptop to the Acendo Vibe as a source device.
Acendo Vibe is plug-and-play with PC/laptop using standard UAC/UVC drivers.
The USB connection is also used to configure the Acendo Vibe via the Acendo Vibe Configuration Tool
for settings and firmware updates.
3-pin captive-wire connector provides serial communication with the Acendo Vibe. Refer to the Serial
Commands section on page 31 for command definitions.
The Baud Rate for the RS-232 connector is 115200.
3-pin captive-wire connector provides connectivity for an (optional) motion sensor (reserved for future
implementation):
• PWR (+5V 0.1A)
• OCC
• Ground
The logic of OCC is "High" for occupancy detected, and "Low" for vacancy.
HDMI Output (to display)
USB (Type B)
power supply to this barrel connector. Only use the power supply included
Installing Acendo Vibe
cable strap
11