Acv-2100 Connectors; Rotating The Acendo Vibe Into The Seated Position - AMX ACV-2100 ACENDO VIBE Instruction Manual

ACV-2100 Connectors

The connectors on the ACV-2100 are shown in FIG. 12: .
FIG. 12
ACV-2100 connector bay
ACV-2100 Connections
DC POWER
OPTICAL AUDIO:
AUX OUT
AUX IN
USB
RS-232
Run each cable through the cable pass-thru in the bracket/door and under the cable strap.

Rotating the Acendo Vibe Into the Seated Position

After connecting all cables, close the Bracket to return the Acendo Vibe to its seated position. The Bracket is secured via
internal magnets (FIG. 13):
FIG. 13
Rotating the Acendo Vibe into its seated position
Acendo Vibe Conferencing Soundbars - User Guide
DC Power input
Optical audio input
cable strap
Analog audio output
Analog audio input
RS-232 (3-pin captive wire)
Connect the included 15V
the ACV-2100.
Use this TOSLINK connector to receive Optical Stereo Input from an audio source device.
Use this 1/8" mini-stereo connector to send analog stereo sound from the ACV-2100 to an auxiliary device.
Use this 1/8" mini-stereo connector to receive analog stereo sound from an analog audio source device.
Use the USB 2.0 Type-B port to connect a PC/laptop to the ACV-2100 as a source device.
Acendo Vibe is plug-and-play with PC/laptop using a standard UAC driver.
The USB connection is also used to configure the ACV-2100 via the AMX Acendo Vibe configuration
application and for file transfers.
3-pin captive-wire connector provides serial communication with the Acendo Vibe. Refer to the Serial
Commands section on page 31 for command definitions.
The Baud Rate for the RS-232 connector is 115200.
Rotate the Acendo Vibe into seated position
(Bracket is secured with magnets)
USB (Type B)
power supply to this barrel connector. Only use the power supply included with
open
Installing Acendo Vibe
cable strap
closed
front
12