Mounting The Wall Mount Bracket And Attaching The Acendo Vibe - AMX ACV-2100 ACENDO VIBE Instruction Manual

Mounting the Wall Mount Bracket and Attaching the Acendo Vibe

1.
Use the Wall Mount Bracket as a template to mark the locations for the four mounting screws (not included). Use
mounting screws and hardware appropriate for the surface being utilized to secure the Bracket to the wall.
Optionally, if not hiding them behind the drywall, place the four included Wall Mount Spacers between the Bracket
and the wall to create a 5mm gap for routing flat cables (FIG. 10).
FIG. 10
Wall Mounting the Acendo Vibe
2.
Attach the Acendo Vibe to the Bracket by sliding the pins on the Bracket into the hinges on the rear of the main unit
(see FIG. 7):
Position the Acendo Vibe with the bottom panel facing the wall and align the hinges on the main unit with the
a.
pins on the Bracket.
Carefully slide the pins into the hinges, until the Bracket snaps into place.
b.
Note: Press the Bracket into place so that the last pin depresses the Release Button, allowing the pins to slide into
the hinges (see FIG. 7)
With the Acendo Vibe attached to the Bracket, rotate the unit up to its seated position. Note that the Bracket
c.
snaps shut and is held closed via internal magnets.
Note: Ensure that cables do not obstruct the complete closing of the unit.
3.
Connect cables as necessary (inside the connector bay - see FIG. 11 on page 11 and FIG. 12 on page 12).
4.
Rotate the Acendo Vibe into seated position. The Bracket is secured with magnets (FIG. 13).
Acendo Vibe Conferencing Soundbars - User Guide
a Mount the Bracket to the
wall via 4 mounting screws
Attach the Acendo Vibe to the
b
Bracket via hinges & pins
mounting spacers (x4, optional)
mounting screws
(x4, not included)
Cable Pass-Thru
Installing Acendo Vibe
Note: Use M4 or #8 mounting screws
10