Operating Mode; Configuring Load Segment - ION F-16 User Manual

AR Automatic restart
GF Green function
bZ Buzzer control
LS1 Load segment 1
LS2 Load segment 2

4.2 Operating Mode

Normal range mode: Under Input mode, the UPS accepts AC input voltage
range for +/-20%.
Generator mode: Under generator mode, the low frequency transfer point can
go as low as 40Hz and as high as 70Hz before being transferred to battery
mode.
Wide range mode: Under Input settings mode, the UPS accepts AC input
voltage range for -30% ~ +20%.
Battery mode
When the UPS is operating during a power outage, the alarm beeps once every
four seconds and the LCD display shows "bATT" to indicate the UPS is working on
battery mode.
If battery volume becomes low while in Battery mode, the alarm beeps once every
second and the LCD display string shows "bATL".
Standby mode
When the UPS is turned off and remains plugged into a power outlet, the UPS is
on Standby mode. The LCD display string shows "STbY" to indicate that power is
not available to your equipment. The battery recharges when necessary.

4.3 Configuring Load Segment

Load segments are sets of receptacles that can be controlled through the display.
Each UPS has two configurable load segments. See "Rear Panels" on page 30 for
load segment for each UPS model.
Note: This configuring can be operated when UPS is power on.
To configure the load segment through the display:
1. Enter settings mode: Press and hold the Enter button
UPS will then transfer to setting mode.
2. Select settings items: Press the Select button
show as Table 5.
[000]=Disable
[000]=Disable
[000]=Disable
[000]=Turn off
[000]=Turn off
to select the setting items
20
[001]=Enable
[001]=Enable
[001]=Enable
[001]=Turn on
[001]=Turn on
for 3 seconds. The