4. Take off the front panel, and connect the battery terminal (A) from UPS to
EBM terminal (B) shown as below. Users need to remove the small gate (C)
on side of the front panel to allow the outlet wire of the EBM to pass through
the gate and then reassemble front panel.
5. After installing the UPS into the rack, the load can then be connected.
Please make sure the load equipment is turned off before plugging all loads
into the output receptacle.
Connecting Multiple EBMs
1000VA / 1500VA / 2000VA and 3000VA UPS include external battery ports
allowing users to connect multiple EBMs in order to provide additional backup
time. Follow the procedure to install multiple EBMs below.
B
A
C
12