Carrying Tool - Makita LW1401 Instruction Manual

1. Spacer block
When cutting workpieces over 85 mm wide at an angle,
attach a straight piece of wood (spacer) over 190 mm
long x 45 mm wide to the guide plate as shown in the
in the guide plate. Make sure that the cut-off wheel does
not contact the spacer when the tool head is depressed.
1
2
3
1. Guide plate 2. Spacer block (over 190 mm long
x45 mm wide) 3. Workpiece (over 85 mm wide)
4. Vise plate
When the cut-off wheel has worn down, raise the cutting
position by putting a spacer block which is slightly nar-
will help you to utilize the wheel economically.
1
4
10 ENGLISH
1
1. Vise plate 2. Workpiece diameter 3. Guide plate
4. Spacer block width
Long workpieces must be supported by blocks on
either side so that it will be level with the base top. Use
1. Supporting block

Carrying tool

Fold down the tool head and lock it. Hold the handle
when carrying.
2 3
4
1