Self-Test; Main Menu; Figure 3-2 Program Download Display; Figure 3-3 Revision Display - Magtrol DSP6001 User Manual

Chapter 3 – Installation/Configuration
3.1.2 S -t
eLf eSt
After turning the power on to the DSP6001, the display panel will show all segments of the VFD
(series of rectangles), indicating that the DSP6001 is downloading the program.
When the program download is complete, the message "MAGTROL MODEL DSP6001 Revision
X.X" appears.
If the alarms are disabled, the following display message will appear at this time.
To activate the alarms, refer to Section 6.1.2.1 – How to Enable/Disable Alarms.
3.1.3 M M
ain enU
When the DSP6001 is completely powered up and ready for use, the main menu will appear on the
display.
POWER TORQUE
BRAKE STATUS SET POINT
Figure 3–2 Program Download Display
POWER TORQUE
BRAKE STATUS SET POINT
Figure 3–3 Revision Display
POWER TORQUE
BRAKE STATUS SET POINT
Figure 3–4 Alarm Warning Display
POWER TORQUE
BRAKE STATUS SET POINT
Figure 3–5 Main Menu
Magtrol Model DSP6001 Dynamometer Controller
SPEED
SET POINT
SPEED
SET POINT
SPEED
SET POINT
SPEED
SET POINT
16
STATUS
P I D
STATUS
P I D
STATUS
P I D
STATUS
P I D