Table of Contents
Advertisement
7. Reboot the system and note the message displayed when the SSP-100 Client Driver is
loaded. If the Client Driver reports an "invalid command line option", correct the
entry in the CONFIG.SYS file and reboot the system again. If the Client Driver
reports "Card and Socket Services not found", a version of Card and Socket Services
must be installed on the system or the SSP-100 Enabler program must be used to
configure the adapter. If the Client Driver reports the desired adapter configuration,
the installation process is complete and the SSP-100 may be removed and/ or inserted
from the system as desired. On each insertion into the PCMCIA socket, the SSP-100
will be automatically reconfigured according to the command line options.
2.1.2 Command Line Options
The SSP-100 Client Driver accepts up to eight command line arguments from the user to
determine the configuration of theSSP-100. If any arguments are provided, the Client Driver will
attempt to configure any SSP-100s with the options specified in the order they are entered on the
command line. Each argument must be enclosed in parenthesis and must be separated from other
arguments by a space on the command line. Within each argument, any or all of the following
parameters may be specified using a comma (no spaces) to separate each parameter:
Baddress
specifies a the base I/O address of the SSP-100 in hexadecimal. This address must
reside on an even 8-byte boundary. If this option is omitted, a base address will be
assigned by Card and Socket Services.
Iirq
specifies the interrupt level (IRQ) of the SSP-100 in decimal. irq must be one of the
following values: 3, 4, 5, 7, 9, 10, 11, 12, 14, 15, or 0 if no IRQ is desired. If this
option is omitted, an interrupt level will be assigned by Card and Socket Services.
Ssocket
specifies which PCMCIA socket the SSP-100 must be inserted into for this
configuration argument to be used. socket must be in the range 0 - 15. If this option
is omitted, the configuration argument will apply to SSP-100s inserted into any
socket.
2.1.2.1 Example 1
DEVICE = C:\SSP-100\ SSP130CL.SYS
In example 1, no command line arguments are specified. The Client Driver will configure a
SSP-100 inserted into any socket with a base address and IRQ assigned by Card and Socket
Services.
DOS/Windows 3.x
2-4
Advertisement
Table of Contents
