Quatech SSP-100 User Manual page 30

6. Windows 2000 should have chosen an available Interrupt Request setting
automatically when the I/O address range was configured by a Basic Configuration
selection. This default Interrupt Request setting should not need changed as long
as "No conflicts" is displayed in the bottom display region titled Conflicting Device
List. If you are satisfied with Windows 2000 selection then skip the next step
7. To modify the Interrupt Request setting click the resource name and click the
Change Setting button. An Edit Resource window will open up. Inside this window
click on the up/down arrows to the right of the Interrupt Request value. This scrolls
you through all of the allowable resources for your hardware. Pay attention to the
conflict information at the bottom of the window. Do not select a value that causes a
conflict with any other installed hardware.
8. If any changes have been made to the SSP-100's configuration the card will
automatically be reconfigured to the new resources specified. Any time a PCMCIA
card of this type is inserted Windows 2000 will attempt to configure the card at these
resource settings. Click the Use Automatic Settings box to reset this card type for
automatic configuration.
4-10 SSP-100
(Rev. G and later)
User's Manual