Yeastar Technology TG200 User Manual page 67

Set up Static Routes
Procedure
1. Navigate to Settings > System > Network Preferences > Static Routes.
2. Configure the static route.

Destination: enter the destination IP address or IP subnet for the TG gateway to reach
using the static route.

Subnet Mask: enter the subnet mask for the destination address.

Gateway: enter the gateway address. The TG gateway will reach the destination address
via this gateway.

Metric: the cost of a route is calculated using what are called routing metric. Routing metrics
are assigned to routes by routing protocols to provide measurable values that can be used
to judge how useful (how cost) a route will be.
Note: Leave this field blank if you do not know the information.

Interface: select the network interface. The TG gateway will reach the destination address
using the static route through the selected network interface.
3. Click Add, you can see the new created static route on the Routing Table.
TG Series User Guide
67/86