Installation Instructions; Preparing For Installation; Cooktop Installation - Dacor Epicure EG366 Installation Instructions Manual

PREPARING FOR INSTALLATION
IMPORTANT: Within the Commonwealth of Massachusetts,
this appliance must be installed by a licensed plumber or
gas fitter.
Gas and Electric Service Installation
Have the gas service installed by a qualified professional
in the location determined in the Planning the Installation
section. The gas service must include a gas shut-off valve
(not included with the cooktop) in the main gas supply line in
an accessible location under the cooktop.
Have the electrical receptacle installed by a licensed
electrician in the location determined in the Planning the
Installation section.
Unpack the Cooktop
COOKTOP INSTALLATION
• Lower the cooktop into the cut-out while feeding the electrical
cord into the utility cut-out. Center the cooktop in the cut-out.
• Secure the cooktop to the countertop utilizing the two (2)
hold-down bolts and flat washers provided. Do not over-
tighten the bolts.
IMPORTANT: Do not fasten or seal the cooktop to the
countertop using glue or caulk. The unit must be readily
removable for service. The warranty does not cover
damage due to improper installation.
Gas Line Connection
Unpack the parts box and verify that all required
components have been provided, tf any item is missing or
damaged, please contact your dealer immediately. Do not
install a damaged or incomplete appliance. The customer
must report cosmetic issues within 30 days of installation.
Parts List
3 Grates*
4 Stack Burner Caps**
4 Stack Burner Rings**
2 Crown Burner Caps
2 Crown Burner Rings
2 Crown Burner Heads
• Hold Down BoltstWashers
• 6 Knobs ***
• Stainless Steel Cleaner
• Literature Kit
• Ignitor Cleaning Brush
• WOK Ring
• Griddle
* Three 14-Inch grates for model EG486. Two 10-Inch and
one 14 Inch grate for model EG366.
** Two (2) large, two (2) small
*** Four (4) standard knobs and two (2) "MAX GRIDDLE"
knobs.
NOTE: The cooktop also includes a thread ring removal
tool (PN 101539). It is attached to the cooktop inside the
utility access hole on the bottom of the chassis. Return it
after use so that it is available if needed in the future.
8 _ac:,',r
NOTE: The gas pressure regulator is pre-set at the factory
for the type of gas intended for use with the appliance. To
verify that the appliance is compatible with the type of gas
available, check the cooktop data plate on the under side
of the chassis. Cooktops intended for use with LP gas will
have "LP" as a part of the model number. Consult your
dealer if the cooktop is not compatible with the type of gas
supplied.
• Install the regulator upstream from the pipe nipple, between
the shut-off valve and the appliance. Mount it as close as
possible to the gas inlet on the cooktop for best performance.
The 3/4" male NPT gas inlet for the cooktop is located on the
bottom, at the right rear of the chassis. Ensure that the arrow
on the regulator points in the direction of the gas flow towards
the cooktop.
• Complete connection of the gas supply to the cooktop by
installing 1/2 inch flexible gas line (not included with the
cooktop) between the pressure regulator and the gas shut-off
valve. The cooktop has a 3/4" (19mm) diameter pipe nipple
inlet.