Ethernet Radio Control Screen; In-Service Controls; User Controls - Alcatel-Lucent MDR-8000 User Manual

OR/RT
OC3
Facility
LPBK
MUX
OT/RR
I
O
Switch
CMD

ETHERNET RADIO CONTROL SCREEN

6.11
See Figure 6 - 17. The Control screen is used to enable or disable and display the status
of manual controls. Manual controls include equipment and function in-service con-
trols, system loopback controls, user controls, and DS1 loopback controls. The green
square indicates control is enabled. Highlight and click on control name to change
state.

In-Service Controls

6.11.1
In service controls are used to force A or B transmitter, receiver, and I/O interface mod-
ules on-or off-line. IN-SERVICE manual controls are also used to lock the A or B trans-
mitter ATPC function high ( ATPC High Power Lock) or low ( ATPC Low Power Lock).
6.11.2

User Controls

USER CONTROLS , defined by the customer and named on the User Control Names
Setup screen, are displayed and can be enabled or disabled if the optional AE-27( )
Relay Interface module is installed.
6 - 18
4 x 39
MUX
Translator
I
O
OC3
Equipment
LPBK
Switch
CMD
Figure 6 - 16 OC3/STM-1 Loopbacks
I/O INTFC
SMCRA
RC3
Equipment
LPBK
MUX
I
O
Switch
CMD
XMTR
RT
RCVR
RR
MDR-1094
12/14/04