Oc3/Stm-1 Radio Control Screen; In-Service Controls; System Loopback Controls; User Controls - Alcatel-Lucent MDR-8000 User Manual

OC3/STM-1 RADIO CONTROL SCREEN

6.10
See Figure 6 - 14 . and Figure 6 - 15 The Control screen is used to enable or disable and dis-
play the status of manual controls. Manual controls include equipment and function in-
service controls, system loopback controls, user controls, and DS1/E1 loopback controls.
The green square indicates control is enabled. Highlight and click on control name to
change state.
6.10.1

In-Service Controls

IN-SERVICE controls are used to force A or B transmitter, receiver, and I/O interface
(OC3/STM-1) modules on-or off-line. IN-SERVICE manual controls are also used to lock
the A or B transmitter ATPC function high (ATPC High Power Lock) or low (ATPC Low
Power Lock).
6.10.2

System Loopback Controls

See Figure 6 - 16 for SYSTEM LOOP-BACK. All loopbacks occur in the SMCRA on the I/O
interface module. Loopback functions in both directions are bridged type functions. Data
both loops back and continues. Loopbacks are named by facility in the direction of the loop.
When enabled,
A/B OC3/STM-1 Facility
radio RCV/optical XMT output. When enabled,
demultiplexed RCV output of the DEMUX circuit into the input to the MUX circuit.When
enabled,
A/B RC3 Equipment
DEMUX circuit.

User Controls

6.10.3
USER CONTROLS, defined by the customer and named on the User Control Names Setup
screen, are displayed and can be enabled or disabled if the optional AE-27( ) Relay Inter-
face module is installed.
6 - 16
loops the optical RCV/radio XMT input to the
A/B OC3/STM-1 Equipment
loops the output of the MUX circuit into the input of the
loops the