Configuring Clocking Dcr For Msp Au4-E1 In Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring Clocking DCR for MSP AU4-E1 in CESoPSN

1
Configuring Clocking DCR for MSP AU4-E1 in CESoPSN
To configure clock source on MSP for the working controller, use the following commands:
enable
configure terminal
controller sdh 0/3/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure CEM interface, use the following commands:
interface cem <bay>/<slot>/<port>
cem <cem-group-no>
rtp-present
To configure the recovered clock with priority 1, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 differential cem 1 priority 1
end
To configure clock source on MSP for the protect controller, use the following commands:
enable
configure terminal
controller sdh 0/4/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure CEM interface, use the following commands:
interface cem <bay>/<slot>/<port>
cem <cem-group-no>
rtp-present
To configure the recovered clock with priority 1, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 differential cem 2 priority 2
end
Verifying Clocking DCR for MSP AU4-E1 in CESoPSN
Use the show recovered-clock command to verify the DCR for AU4-E1 in CESoPSN:
Router# show recovered-clock
Recovered clock status for MSP-DCR 200
----------------------------------------
Clock
Priority
5
1
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
124
Type Mode
OCx-T1 DIFFERENTIAL 44
Configuring MSP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module
CEM Status Circuit-No
ACQUIRING 200/4/1/1(acr/path/vtg/t1) ACQUIRING
Working Protect
ACQUIRING