Reset Communication Card (For Modbus Tcp); Additional Setting For Communication Card (For Modbus Tcp); Status Of Communication Card (For Modbus Tcp) - Delta CP2000 Series User Manual

Delta fan/pump vector control drive

Hide thumbs Also See for CP2000 Series:

Table of Contents

 Pr.09-76~09-79 needs to use with communication card.

Address Mask 1 of the Communication Card (for Modbus TCP)

Address Mask 2 of the Communication Card (for Modbus TCP)

Address Mask 3 of the Communication Card (for Modbus TCP)

Address Mask 4 of the Communication Card (for Modbus TCP)

Gateway Address 1 of the Communication Card (for Modbus TCP)

Gateway Address 2 of the Communication Card (for Modbus TCP)

Gateway Address 3 of the Communication Card (for Modbus TCP)

Gateway Address 4 of the Communication Card (for Modbus TCP)

Password for Communication Card (Low word) (for Modbus TCP)

Password for Communication Card (High word) (for Modbus TCP)

Reset Communication Card (for MODBUS TCP)

1: Reset, return to factory setting

bit 0: Enable IP Filter

bit 1: Internet parameters enable(1bit)

When IP address is set up, this bit needs to be enabled to write down

the parameters. This bit will change to disable when it finishes saving

the update of internet parameters.

bit 2: Login password enable(1bit)

When enter login password, this bit will be enabled. After updating the

parameters of communication card, this bit will change to disable.

bit 0: password enable

When the communication card is set with password, this bit is enabled.

When the password is clear, this bit is disabled.

Chapter 12 Description of Parameter SettingsCP2000

Factory Setting: 0

Factory Setting: 1

Factory Setting: 0

Show Quick Links

Table of Contents