Optional Connections - Mitel ST100DA Quick Install Manual

Connections (cont'd.)

Optional Connections

After connecting the voice switch to the LAN, you can make optional connections, including input
from a music-on-hold source or output to an internal paging system.
1. Connect a music-on-hold source (CD player or other audio source) to
the audio input port.
Connect your site's paging system to the audio output port. Mitel
2.
provides a Paging Adapter to facilitate paging connections. Refer to the
Mitel Paging Adapter Quick Install Guide for more information.
Connecting a T1/E1 Line
After setting up the network connections and configuring the ST100DA Voice Switch for operations,
you can connect your T1 or E1 line to the switch.
Use an RJ-45 T1 or E1 cable to connect your T1 or E1 line to the Telco port.
For detailed information on switch port and trunk configuration, refer to the sections "Configuring
Switches" and "Configuring Trunks" in the Mitel Connect System Administration Guide.
Connecting Trunk and Telephone Lines
Use an RJ-21 cable and the provided cable retainer to connect the voice switch to the telephone
company's punch-down block or patch panel.
1. Use a #1 Phillips screwdriver to remove the two screws on
either side of the RJ-21X port, then place the retainer on the
port and re-attach the screws.
2. Plug the Telco cable into the port, then pull the Velcro strap
tightly around the cable connector and fasten it.
3. Connect the other end of the Telco cable to the punch-down
block or patch panel.
CAUTION: To reduce risk of fire, use only No. 26 AWG or larger (e.g. 24 AWG) UL Listed or CSA
certified telecommunication line cord.
VORSICHT: Um das Brandrisiko zu verringern, verwenden Sie nur Telekommunikationsleitungen
Nr. 26 AWG oder größer (z.B. 24 AWG) mit UL- oder CSA-Zulassung
For detailed information on switch port and trunk configuration, see the "Configuring Switches"
and "Configuring Trunks" sections in the Mitel Connect System Administration Guide.