Advertisement
Connections
Servicing Procedures
WARNING: ST1D/ST2D switches contain no internal field serviceable parts. Return the
equipment to Mitel for any required service procedures.
CAUTION: Internal fuses should be serviced only by qualified Mitel personnel. If internal fuses
are blown and require replacement, return the ST1D/ST2D switch to Mitel for service.
WARTUNGSVERFAHREN
ACHTUNG: ST1D/ST2D enthält keine internen Teile, die vor Ort gewartet werden können.
Senden Sie das Gerät an Mitel, falls Wartungsarbeiten erforderlich sein sollten.
VORSICHT: Interne Sicherungen dürfen nur von qualifizierten Mitel-Mitarbeitern gewartet
werden. Wenn interne Sicherungen ausgetauscht werden müssen, senden Sie den ST1D/
ST2D zur Wartung an Mitel.
Connecting the Voice Switch to the Network
Powering on the Voice Switch
After connecting the switch to the network, power on the device by connecting it to an AC
power source.
Plug an AC surge protector (not provided) into a grounded AC power source.
1.
2.
Plug one end of the provided power cord into the receptacle on the back of the switch,
then plug the other end into the AC surge protector.
The power LED flashes momentarily, and remains lit.
•
If the LED is not lit, make sure the power cord is plugged into the switch and the power
source.
•
If the LED continues flashing, there is an internal error. Unplug the switch to power it off,
then power it back on. Refer to the "Configuring Switches" chapter in the Mitel Connect
System Administration Guide for information on flash patterns, or contact technical
support at http://www.mitel.com/shoretel.
The LAN ports auto-sense the network transport rate. When the network connection is
established, the network LED indicates a transport rate of 10/100/1000 Mbps, and whether the
switch is receiving and transmitting data.
Optional Connections
After connecting the voice switch to the LAN, you can make optional
connections, including input from a music-on-hold source or output to
your internal paging system.
1.
Connect a music-on-hold source (CD player or other audio source)
to the audio input port.
2.
Connect your site's paging system to the audio output port. You can
use a Paging Adapter to facilitate paging connections. Refer to the
Paging Adapter (PA-1) Quick Install Guide for more information.
Connecting a T1/E1 Line(s)
After setting up the network connections and configuring the ST1D/
ST2D Voice Switch for operations, you can connect your T1 or E1 line(s)
to the switch.
Use an RJ-45 T1 or E1 cable to connect your T1 or E1 line(s) to the
Telco port(s).
For detailed information on switch port and trunk configuration, refer to
the sections "Configuring Switches" and "Configuring Trunks" in the Mitel
Connect System Administration Guide.
Once the ST1D/ST2D Voice Switch is secured to a rack, surface-
mounted, or wall mounted, you can connect it to the data network.
Use an RJ-45 Ethernet cable to connect one or both of the LAN ports
to the network subnet.
While both ports can detect and respond to link status, the switch cre-
ates a data connection on only one LAN port at a time.
Advertisement
