Microplex PP 803 User Manual page 6

Electromagnetic Compatibility
We certify that the equipment at issue,
Type: Printer PP 803, PP 806, and Printer PP 809
Corresponds to the law regulations ruling electromagnetic compatibility of ap-
pliances (89/336/EWG) and, therefore, fulfills the requirements for conformity
marking with the CE-sign.
For standard printer with serial and parallel interface (Ser/Par PM) please note: This
equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular in- stallation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on. The user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from the
circuit to which the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
For printer with all other interface please note:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
4