Operating Range Of The Remote Control Unit - Pioneer Kuro PDP-LX609A Operating Instructions Manual

Flat screen tv
Table of Contents

Advertisement

05
Preparation

Operating range of the remote control unit

Operate the remote control unit while pointing it toward the remote control
sensor located at the bottom right of the front panel of the flat screen TV. The
distance from the remote control sensor must be within 7 m and the angle relative
to the sensor must be within 30 degrees in the right, left, upward, or downward
direction.
Note
• For remote control sensor locations, see Part names on page 11.
Caution
• Do not expose the remote control unit to shock. In addition, do not expose the
remote control unit to liquids, and do not place in an area with high humidity.
• Do not install or place the remote control unit under direct sunlight. The heat
may cause deformation of the unit.
• The remote control unit may not work properly if the remote control sensor of
the flat screen TV is under direct sunlight or strong lighting. In such case,
change the angle of the lighting or flat screen TV, or operate the remote
control unit closer to the remote control sensor.
• When any obstacle exists between the remote control unit and the remote
control sensor, the remote control unit may not function.
• As the batteries become empty, the remote control unit can function within a
shorter distance from the remote control sensor. Replace the batteries with
new ones early enough.
• The flat screen TV emits very weak infrared rays from its screen. If you place
such equipment operated through infrared remote control as a VCR nearby,
that equipment may not receive commands from its remote control unit
properly or entirely. If this is the case, place that equipment at a location far
enough from the flat screen TV.
• Depending on the installation environment, infrared rays from the flat screen
TV may not allow this system to properly receive commands from the remote
control unit or may shorten allowable distances between the remote control
unit and the remote control sensor. The strength of infrared rays emitted from
the screen differs, depending on images displayed on the screen.
18
En
7 m
30º
30º
Remote
control sensor

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kuro pdp-lx509aKuro pdp-c509a

Table of Contents