Preparing The Remote Control Unit - Pioneer Kuro PDP-LX609A Operating Instructions Manual

Preparation
Attaching and removing a cable clamp
Thread the clamp band through the holder [1] and bundle the cable(s) in the
cable clamp. Push and hold the levers then insert the hook into an appropriate
hole [2] on the rear of the flat screen TV. Pull up the clamp band to lock.
2
• Confirm that the cable clamp is seated firmly in the panel.
To remove the clamp band, pull and hold the latch to release.
To remove the cable clamp, push and hold the levers then pull it out from the hole.
Latch
Note
• Avoid pinching or creating pressure points when routing or bundling cables.
• The longer a clamp is in place, the better chance of deterioration. An older
clamp is more easily damaged while being removed and may not be reusable.
• Use the cable clamps as necessary.
• Be careful not to subject any connecting cables to strain.
Connecting the power cord
T
W
Rear view
Power cord
Note
• Disconnect the power cord from the power outlet when the flat screen TV is
not going to be used for a long period of time.
• Insert the power plug in the AC outlet, after all other components are
connected.
1
Cable clamp
Lever
Lever
T
W
Noise filter
Partially eliminates noise
caused by the power source
To power outlet

Preparing the remote control unit

Inserting batteries
1 To open push and slide the battery cover in the direction of the arrows.
2 Load the supplied two AA size batteries while inserting their respective
negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+) and (–) indicators in
the battery compartment.
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an explosion. Be sure
to follow the instructions below.
• When you replace the batteries, use manganese or alkaline ones.
• Place the batteries with their terminals corresponding to the (+) and (–)
indicators.
• Do not mix batteries of different types. Different types of batteries have
different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can shorten
the life of new batteries or cause chemical leakage in old batteries.
• Remove batteries as soon as they have worn out. Chemicals that leak from
batteries can cause a rash. If you find any chemical leakage, wipe thoroughly
with a cloth.
• The batteries supplied with this product may have a shorter life expectancy
due to storage conditions.
• If you will not use the remote control unit for an extended period of time,
remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY WITH
GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL PUBLIC
INSTITUTION'S RULES THAT APPLY IN YOUR COUNTRY/AREA.
05
17
En