Basic Connections - Pioneer Kuro PDP-LX609A Operating Instructions Manual

05 Preparation
Caution
• A table or rack with adequate strength should always be used to support the
flat screen TV. Failure to do so could result in personal injury and physical
damage.
• When installing the flat screen TV, please take the necessary safety measures
to prevent it from falling or overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the flat screen TV could fall down and
cause injury.
• The screws, hooks, cords and other fittings that you use to secure the flat
screen TV to prevent it from overturning will vary according to the composition
and thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings after first
inspecting the surface carefully to determine its thickness and composition
and after consulting a professional installer if necessary.
• Do not use bare wires for the cord. If any part of the wire is introduced into the
ventilation port on the back of the display panel, fire or electric shock could
result.

Basic connections

Connecting the antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief
explanation of the types of connections that are used for a coaxial cable.
Rear view
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect a 75-ohm coaxial cable (commercially available) to the ANT terminal.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325
plug (IEC169-2), plug it into the antenna terminal at the rear of the flat screen TV.
Note
• If the antenna is not connected correctly, the quality of reception may be
impaired. If images are not displaying correctly, check whether the antenna
connection is correct or not.
16
En
T T
W W
Routing cables
When the speaker is mounted to the flat screen TV panel:
(PDP-LX609A)
Speaker cable
(PDP-LX509A)
Speaker cable
(PDP-C509A)
Speaker cable
T
W
Cable clamp
Note
• Use the supplied cable clamps as necessary.
• When tidying up your speaker cables, make sure to bundle them so that they
are not subjected to any pressure.
Attaching cable clamps to the main unit
Use the cable clamps as necessary to route the connecting cables. The diagrams
below show the location of the holes on the rear of the flat screen TV.
(PDP-LX609A)
(PDP-LX509A)
T
W
Clamp hole locations for PDP-C509A are the same as PDP-LX509A.
(Under speaker)
Cable clamp
(Under speaker)
Cable clamp
T
W
(Side speaker)
T
W