Clearing Jams - King Canada 8245RN Instruction Manual

LOADING NAILER & CLEARING JAMS
LOADING NAILER MAGAZINE
• Disconnect the air hose from the coil roofing nailer air inlet.
• Pull down latch and swing open the magazine cover.
• The tool must be set for the length of the nail to be used. Nails will not feed smoothly if the magazine is
not correctly adjusted. The magazine contains an adjustable nail platform called an adjuster plate on
which the nail coil rests. The adjuster plate height can be adjusted up or down by turning the adjuster
nut above it. Adjust the adjuster plate height to suit the nail length you are about to load.
• Place the coil of nails over the magazine post. Uncoil enough nails to reach the feed pawl. Place the
first nail in front of the front tooth on the feed pawl in the driver channel. The nail heads must be in the
slot in the nose.
• Swing the latch door and magazine cover closed. Check to make sure that the latch pin engages when
released and that the magazine cover is locked behind the latch.

CLEARING JAMS

Disconnect the coil roofing nailer from the air compressor before adjusting, clearing jams, serv-
icing, relocating and during non-operation.
• Disconnect the air hose from the coil roofing nailer air inlet.
• Pull down latch and swing open the feeder cover, then open the magazine cover.
• Pull nails away from the nose.
• Grab the jammed nail with pliers and remove.
• Close magazine cover and close latch securely.