Lubrication And Maintenance; Air Supply And Connections - King Canada 8245RN Instruction Manual

AIR SUPPLY AND CONNECTIONS

LUBRICATION AND MAINTENANCE

• Your coil roofing nailer needs to be lubicated before and after the first time you use it.
• Disconnect the air supply from the coil roofing nailer before lubricating.
• Turn the coil roofing nailer so that the inlet is facing up and put ONE DROP of high speed spindle oil or
oil without detergent into the air inlet. Never use detergent oil or additives. Operate the nailer briefly
after adding oil.
• Wipe off excessive oil at the exhaust. Excessive oil will damage O-rings of the coil roofing nailer. If a in-
line oiler is used, manual lubrication through the air inlet is not required on a daily basis.
THE FOLLOWING ILLUSTRATION SHOWS THE CORRECT MODE OF CONNECTION TO THE AIR SUPPLY
SYSTEM WHICH WILL INCREASE THE EFFICIENCY AND USEFUL LIFE OF THE NAILER.
Quick connector
• Many air tool users find it convenient to use an oiler to help provide oil circulation through the tool and
it increases the efficiency and useful life of the tool. Check oil level in the oiler daily.
• Many air tool users find it convenient to use a filter to remove moisture and impurities which can rust
or wear internal parts of the tool. A filter also increases the efficiency and useful life of the tool. The
filter must be checked on a daily basis and, if necessary, drained.
• For better performance, install a 3/8" quick connector (1/4" NPT threads) with an inside diameter of
.315" on your tool and a 3/8" quick coupler on the air hose.
LUBRICATION
AIR SUPPLY AND CONNECTIONS
WARNING!
Air hose Quick
Oiler
connector
Quick couplers
Regulator
Filter
Compressor