Table of Contents
Advertisement
OPERATING YOUR NAILER
OPERATING YOUR COIL ROOFING NAILER
WARNING! protect your eyes and ears. Wear Z87 safety glasses with side shields. Wear hearing
protection. Employers are responsible for ensuring the user or anyone near the nailer wears the
above mentioned safety protection.
WARNING! Check and replace any damaged or worn components.
• Add one/two drops of 30W oil for air tools into the air inlet.
• Install a quick connect fitting to the coil roofing nailer.
• Connect the coil roofing nailer to an air compressor using a 3/8" I.D. hose. Make sure the magazine
does not contain any nails and that the air hose has a rated working pressure exceeding 200 psi and
a female quick coupler.
• Regulate the air pressure to obtain 70 psi. Check the operation of the contact safety trip mechanism fol-
lowing the instructions in this manual.
• Disconnect the coil roofing nailer, then load magazine with nails following loading instructions.
• Reconnect the air hose to the coil roofing nailer air inlet.
• Test for proper nail penetration by driving nails into appropriate scrap material. If the nails do not achieve
the desired penetration, regulate the air pressure to a higher setting until the desired penetration is
achieved. Do not exceed 120 psi.
Advertisement
Table of Contents
