D-Link DSL-500 Command Reference Manual page 12

pmstop
- stop transmission/reception of PM cells
pmstats
22. portcli
8khzsource [<port> [int|off]]
errors [diff]
help [all|<command>]
portinfo [<port>]
portload [<port>]
portmode <port>|all uni30|uni31|uni40|iispuser|iispnet|mast|gsmp|ifmp
setportflag <port>|all <portflag>
show <port>
speed <port> [tx default|<cps>][rx default|cps] - set port speed
stats [diff]
unsetportflag <port>|all <portflag>
version
vport
23. ppp
bcp
clear
disable
discard
echo
enable
DSL-500 Console Commands Index and Syntax
<port> <vpi> <vci> <flags> <dir>
<port> <vpi> <vci> <flags> - display PM stats
- show error counts
- print help information
- <channel> bcp stp|nostp:
set if BCP uses spanning tree packets over this
channel
- <channel> clear:
clear channel to initial state
- <channel> disable:
disable PPP on this channel
- <channel> discard [<size>]:
send LCP 'discard' packet
- <channel> echo [<size>]:
send LCP 'echo' packet
- <channel> enable [pppoe]:
enable this channel with current settings
- set source of 8kHz reference signal
- show port information
- show port loading
- set port mode (group of flags)
- set port flag
- show detail information for a port
- print statistics
- clear port flag
- show switch CLI version
- add or remove virtual ports
12