Yaesu FT-818ND Operating Manual page 13

FUNC Keys
These three keys select many of the most important operating features of the trans-
ceiver. When pressing the
of the , ,
scrolls the display through eleven rows of functions available for use via the
keys.
The available features are shown in chart on the next page.
BAND ( DWN ) /BAND ( UP ) Key
Pressing either of these keys momentarily will cause the frequency to be moved up or
down by one frequency band. The selections available are:
1.8 MHz 3.5 MHz
430 MHz 144 MHz
MODE (  ) /MODE (  ) Key
Pressing either of these keys momentarily will change the operating mode. The selec-
tions available are:
LSB USB
HOME Key
Pressing this key momentarily recalls a favorite "h
SEL Knob
This detented rotary switch is used for tuning, memory selection, and function selec-
tion for the ,
CLAR Key
Press this key momentarily to activate the Receiver Clarifier feature. When this feature
is activated, the
transmitter's frequency is not affected by the setting of the Clarifier.
Press and hold this key for 1/2 second to activate the IF Shift feature, which allows
you to use the
sponse.
ANT Jack
Connect the supplied 50/144/430 MHz rubber flex antenna (or another antenna pre-
senting a 50Ω impedance) to this BNC connector.
In its default setting, this jack does not function on the HF bands. If you want to enable
this jack on the HF bands, recall and change the setting of Menu #07.
Front Panel Control & Switches
key, the current function of that key appears above each
keys (along the bottom of the LCD); rotating the
5.0 MHz 7.0 MHz
108 MHz 88 MHz
CW CWR
, keys of the transceiver.
knob may be used to set a tuning offset of up to ±9.99 kHz. The
knob to adjust the center frequency of the IF filter's passband re-
10 MHz 14 MHz
50 MHz 28 MHz
AM FM
" frequency memory.
ome
knob
,
15 MHz 18 MHz
24 MHz 21 MHz
DIG PKT
11
,