Re-Adjustment Of Tools - Bosch OptiMUM MUM9 Series Instruction Manual

Hide thumbs Also See for OptiMUM MUM9 Series:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  1000 g flour
  3 sachets dried yeast
  2 tsp salt
  660 ml warm water
  ■ Mix all ingredients with the kneading 
hook for approx. ½ minute at setting  , 
then for approx. 4-5 minutes at setting  .
W R i sk of injury!
Pull out the mains plug before re-adjusting.
Only re-adjust tools in small steps. It must 
be possible to completely lower the swivel 
arm, and when doing so, the tools should 
not catch on the bottom or on the edge of 
the bowl. The optimum distance between 
the tools and the bowl is 3 mm.
X I m age sequence
  ■ Insert the professional stirring whisk and 
check the current setting.
  ■ Press the release button and raise 
the swivel arm to the stop.
  ■ Hold the tool with one hand. Release 
the lock nut in a clockwise direction 
using a spanner wrench (10 mm).
  ■ Adjust the distance to the bowl by 
turning the tool (1 whole turn corre-
sponds to a height adjustment of 1 mm). 
Distance to bowl is reduced. 
Distance to bowl is increased.
  ■ Press the release button and push the 
swivel arm down until it locks into place.
  ■ Check the tool distance. The optimum 
distance between the tools and the bowl 
is 3 mm. Adjust if necessary.
  ■ Once the distance is perfectly adjusted, 
press the release button and move the 
swivel arm back.
  ■ Hold the tool with one hand. Turn the 
lock nut in an anticlockwise direction 
using a spanner wrench (10 mm).
 1,5 x basic recipe
O
Re-adjustment of tools
The appliance can only be switched on if 
the bowl has been inserted and turned until 
it locked into place, or if an accessory has 
been secured to the main drive with the 
bevel gear, and if the swivel arm is locked 
into the lower position.
If the power is interrupted, the appliance 
remains switched on, but the motor does 
not start again when power is restored. 
To switch back on, first turn the rotary 
switch to y, and then switch on again.
The overload protection will switch the 
motor off automatically during operation. 
One possible cause may be processing 
too much food at once.
The swivel arm will not unlock and move if 
an accessory is fitted to the rear drive.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents