QSC DSP-3' Specification Sheet page 4

Characteristics
FREQUENCY RESPONSE
Euro Input
DataPort
DISTORTION
DYNAMIC RANGE UNWEIGHTED
COMMON-MODE REJECTION
INPUT SENSITIVITY
(selectable)
CROSSTALK
(inter-channel w/in DataPort pair)
INPUT CONNECTORS
Specifications subject to change
DSP-3 SPECIFICATIONS
Specifications
20 Hz to 10 kHz ± 0.3 dB
20 Hz to 20 kHz ± 0.7 dB
20 Hz to 20 kHz ± 0.2 dB
<0.01% THD+N @ +4 dBu
>93 dB, 20 Hz to 20 kHz
for 1.5, 4, 9V input sensitivities
>88 dB, 20 Hz to 20 kHz
for 18V input sensitivities
>50 dB, 20 Hz–20 kHz typical
>40 dB @ 20 kHz worst case
1.5, 4, 9, 18 Vrms
6, 14.5, 21.5, 27.5 dBu
3.5, 12, 19, 25 dBV
>75 dB separation,20 Hz to 20 kHz
Two 3-pin Euros
(1 for each audio channel)
One HD-15 female DataPort*
One RS-232 female (PC input)
One Power Jack
Required only for PowerLight,
QSC non-DataPort amplifiers,or
non-QSC amplifiers,using
remote rack mounting bracket
A Remote Rack Mounting Bracket is available for PowerLight, 4-channel QSC amplifiers, or for non-DataPort-
equipped amplifiers. Designed to be bolted to the rear of an amplifier rack, up to four modules can be mounted
to each panel, providing up to eight channels of DSP processing in a three rack-unit space.
Characteristics
OUTPUT CONNECTORS
INDICATORS
EXTERNAL POWER REQUIREMENTS 15 VDC, 0.4 A
DIMENSIONS
WEIGHT
CONSTRUCTION
*DataPort input for use with CM16a Amplifier Network Monitor in QSControl audio network
systems for remote management of QSC amplifiers and other audio devices.
Specifications
Two 3-pin Euros
(for daisy-chaining each audio
channel out)
One HD-15, male
amplifier connection
FRONT:
Power (one blue)
Signal (one green)
Required only for PowerLight,
QSC non-DataPort amplifiers,or
non-QSC amplifiers,using
remote rack mounting bracket
3.49" (1.37 cm) height
3.33" (1.31 cm) width
without flanges
4.76" (1.48 cm) width
with flanges
1.21" (0.48 cm) depth
0.6 lbs (0.27 kg) net
1 lb (0.45 kg) shipping
Steel chassis and back cover