QSC DSP-3' Specification Sheet page 3

SIGNAL MANAGER
Advanced "Drag-and-Drop" Software Configuration
DSP configuration is made simple with a PC-based "drag-and-drop"
software program called Signal Manager. Users can access a DSP
"toolbox" and simple drawing tools to configure processing functions
and signal flow. DSP processing power and memory is dynamically
assignable to signal processing functions and any combination of
functions may be configured until the total capacity is used. DSP
resources are graphically displayed at the bottom of the screen.
Configurations can be downloaded directly to the DSP-3 via an RS-232
serial port or through a QSControl Audio Network System* via CM16a
Amplifier Network Monitor for added simplicity. The software package
also offers real-time control and set-and-forget convenience.
Configurations can be saved and recalled for future use.
* Available in early 2001.
DSP-3 CONFIGURATIONS
The DSP-3 mounts directly to the back of these amplifier models via the
DataPort:
• Two-channel CX Series
• Two-channel DCA Series
• PowerLight 2 Series
The following models require a Remote Rack Mounting Bracket:
Full Feature
• Four-channel CX Series
• Four-channel DCA Series
• PowerLight Series
COMPATIBLE AMPLIFIER MODELS
Without Power Limiting
• MX
• USA
• PLX
• RMX
• Non-QSC amplifiers
Whether you need
speaker crossovers,
EQ, time delay, or
subsonic filters, the
DSP-3 is as flexible as
your system's needs.