Q-See QC40198 User Manual page 42

NAVIGATION AND CONTROLS

Event type: from the dropdown list you can select motion detection type.

Channel: select the channel to activate recording function once alarm occurs. Please make sure you have
set MD record in encode interface (Main Menu->Setting->Schedule) and schedule record in manual record
interface (Main Menu->Advanced->Manual Record)

Latch: when motion detection event ends, system auto delays detecting again for a specified time. The
value ranges from 10-300 seconds.
Region: Click select button in the "Region" portion of the Detect menu illustrated in Figure 4-20. Here you

can set the motion detection zone. As illustrated in Figure 4-21 below, there are 396 (22*18 PAL) /330
(22*15 NTSC) small zones. The green square is current cursor position. The Red zone is the motion
detection zone. Black zone is the disarmed zone. You can click the Fn button on the remote to switch
between the arm mode and disarm mode. In arm mode, you can click the direction buttons to move the
green rectangle to set the motion detection zone. After you completed the setup, please click ENTER
button to exit current setup. Click save button to save current setup. If you click ESC button to exit the
region setup interface the system will not save your zone setup.
NOTICE: as shown in Figure 4-21, you can left click the mouse and then drag it to set a region for motion
detection. Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to
exit.

Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.

Show message: System can pop up a message to alert you in the local host screen if you enable this
function.

Alarm upload: System can upload the alarm signal to the network (including alarm center) if you enable this
function.

Send email: System can send out an email to alert you when alarm occurs.

PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to preset, tour & pattern
when there is an alarm. Click "select" button, you can see the interface shown in Figure 4-22. Please note:
motion detection can only activate the preset.
Figure 4-21
33 | P a g e
QC40198 User Manual