Q-See QC40198 User Manual page 107

WEB OPERATION
Please refer to the following chart for detailed information.
Parameter
NAS enable
Server IP
Port
User Name
File length
Password
Remote Path
Save
Refresh
NTP
The NTP interface is shown in Figure 7-42.
Here you can activate network time synchronization. Please enable current function and then input server IP, port
number, time zone and update interval. Please note the SNTP supports TCP transmission only and its port shall be
123.The update interval ranges from 1 to 65535. Default value is 10 minutes.
Function
Select network storage protocol and then enable NAS
function.
Input remote storage server IP address.
Input remote storage server port number.
Log in user account.
The file length you upload to the FTP.
When setup is larger than the actual file length, system
will upload the whole file. When setup here is smaller
than the actual file length, system only uploads the set
length and auto ignore the left section. When interval
value is 0, system uploads all corresponding files.
The password you need to log in the server.
Remote storage file path.
You can click save button after you complete setup for
one channel, or you can complete the whole setups and
then click save button.
Click this button to get device's latest configuration
information.
Figure 7-42
98 | P a g e
QC40198 User Manual