Cobalt Digital Inc BBG-1034-AUD-PRO Product Manual page 112

3
Press and hold MMC BOOT button
1
Power-up card and continue holding
2
button for 3 seconds, then release
button
3-80
COM LED
Figure 3-10 MMC Boot Button
With button now released, the card will begin reprogramming:
3.
COM
•
When reprogram is complete,
•
again (entire process takes about 1-1/2 minute).
Remove power from the card (remove card from slot or power-down
4.
BBG-1000 Series unit).
Re-apply power to the card. The card/device will display as
5.
"UNLICENSED" in DashBoard/remote control.
In Dashboard or web remote control, go to
6.
Restore from SD Card
be restored and card will be using its most recently installed firmware.
Card/device can now be used as normal. On BBG-1000 Series unit,
7.
re-install top cover.
Contact and Return Authorization
Should any problem arise with this product that was not solved by the
information in this section, please contact the Cobalt Digital Inc. Technical
Support Department.
If required, a Return Material Authorization number (RMA) will be issued to
you, as well as specific shipping instructions. If required, a temporary
replacement item will be made available at a nominal charge. Any shipping
costs incurred are the customer's responsibility. All products shipped to you
from Cobalt Digital Inc. will be shipped collect.
The Cobalt Digital Inc. Technical Support Department will continue to
provide advice on any product manufactured by Cobalt Digital Inc., beyond
the warranty period without charge, for the life of the product.
See Contact Cobalt Digital Inc. (p. 1-22) in Chapter 1, "Introduction" for
contact information.
BBG-1034-AUD-PRO PRODUCT MANUAL
FRONT OF CARD
LED illuminates and remains illuminated.
. After about 1/2-minute, the card license(s) will
Troubleshooting
COM LED turns off, on, and then off
tab and click
Admin
BBG-1034-AUDPRO-OM (V1.1)