Yakima HoldUp Plus2 Installation Instructions Manual page 4

fOld hOlduP dOWN.
• Pull spring Pin.
• Fold down holdup
• Spring pin should
snap into place.
INseRT sTABIlIzeR PIN.
• ALWAYS USE
STABALIZER PIN.
• Completely insert pin
into hole. Pin will lock
into place.
• Use pin when HoldUp
Plus2 is in down
position, or up position.
PRePARe fOR lOAdING.
Release wheelstrap by pressing
the lever on the buckle.
lOAd heAvIesT BIKe fIRsT.
Note: HoldUp can fold
down past horizontal to
aid in loading your bikes.
1034431D-4/21
CAUTION: If any part
of your bike comes in
contact with the red
trigger, do not use this
carrier with that bike.
If a fender prevents proper placement
of the wheel hook, remove the fender
for proper and safe loading.
INsTAll sTABIlIzeR PIN.
fOld PIvOT
ARM dOWN.
Do not push
arm beyond
horizontal.
Tuck strap into slot at
rear of whelltray.
Be sure to return the HoldUp to the locked
horizontal position after loading.
• Thread plug
through loop
on lanyard.
• Firmly press
plug into
hole on base.
Do not install your bike
if tire may go flat or has
a slow leak. Lost tire
pressure after install may
result in an insecure load.