Yakima HoldUp Plus2 Installation Instructions Manual page 2

ReMOve eNd cAP
fROM hOlduP.
Using a flathead screwdriver, remove
the end cap from the HoldUp.
INsTAll MAIN BOlT.
75 ft-lbs.
ReMOve fAsTeNeRs.
1034431D-2/21
INseRT Plus2 BAse INTO hOlduP.
Align
• Insert bolt,
• Pull spring pin to
and lock-
washer in
• Lift frame.
order shown.
• Release spring pin. Pin
• Tighten with
adjustable
wrench.
The fasteners are installed in the trays for shipping
purposes. Remove them to prepare for assembly.
ROTATe TO uPRIGhT POsITION.
release base.
should snap into place.
Insert the Plus2
base into the
HoldUp tube,
aligning holes.