Bosch B450 Installation And Operation Manual page 35

Conettix Plug-in Communicator Interfaces
Before you begin
–
–
–
–
–
SMS configuration parameters
ID
1=
2=
4=
Basic parameters
10=
11=
12=
13=
15=
16=
19=
20=
Advanced parameters
Bosch Security Systems, Inc.
Separate each ID or value pair with a semi-colon ; (for example, %1;1=B450;19=1;!). To
allow spanning of configuration across multiple messages, each SMS starts with the
sequence number followed by the command line separator.
Use the ! character to signal the end of the configuration data. Refer to your cellular
phone documentation for available characters.
Add the current SMS configuration passcode in the SMS text message to allow the
module to save the new configuration data.
The configuration message must begin with the sequence number (%1) and must include
the current B450 configuration password (default = B450) followed by the ID number and
the value you want to set.
To remove text from an SMS message, use the word None, or ;. For example, if you want
to remove a SIM PIN using SMS, enter either 4=None or 4=;. The word None is NOT case
sensitive.
Description
Current passcode (4 to 10 characters); default = B450
New passcode (4 to 10 characters)
SIM PIN (4 to 8 characters)
Network Access Point Name (APN): Text characters that can fit in a single text
message
Network Access Point User Name (up to 30 characters)
Network Access Point Password (up to 30 characters)
TCP/UDP port number: 7700 (1 to 65535)
AES encryption
– 0 = disable
– 1 = 128 bit
– 2 = 192 bit
– 3 = 256 bit
AES encryption key (0 to 9, A-F, a-f, based on key size, none, 32, 48, or 64 digits)
Default =
0102030405060708091011121314151601020304050607080910111213141516
Module Enclosure Tamper (V1.0.x control panels on SDI2 bus)
– 0 = disable
– 1 = enabled
Inbound SMS
– 0 = disabled
– 1 = enabled
Installation and Operation Guide
Configuration | en 35
2017.10 | 09 | F.01U.300.740