Usage And Storage Of Paper / Ink Ribbon Set - Mitsubishi Electric CP9000DW Operation Manual

BEFORE OPERATION

USAGE AND STORAGE OF PAPER / INK RIBBON SET

2 2 2 2 2
BEFORE PRINTING
• Fingerprints or dust on the paper's printing surface may degrade the print quality and
cause paper jams.
print paper, two or three prints may be printed with blank parts due to hand oil or dust.
• When the print paper is abruptly transferred from a cool place to a hot place, vapor or dew
is generated on the paper's surface causing paper jams or degraded print quality. Leave
the print paper in the room to stabilize its temperature before using it.
• If you repeat the FEED & CUT procedure more than the designated number of times
while installing the print paper, the indicated number of prints may not be made. In addition,
if you replace the print paper before it is used up, the indicated number of prints may not
be made.
2 2 2 2 2
AFTER PRINTING
• If the paper absorbs nonvolatile organic solvents (alcohol, ester, ketone, etc.) the print may
be discolored.
• Discoloration of prints is accelerated if the print paper comes into contact with soft vinyl
chloride such as transparent tape.
• Avoid storing prints in direct sunlight or places with high humidity.
2 2 2 2 2
STORAGE
• Leaving the print paper in contact with PVC- based materials causes color of prints to
come off and to be stained.
• Never store the print paper in places that are close to heater or in direct sunlight.
Keep the print paper in a place where;
Temperature : 5 ˚C - 30 °C
Humidity
16
If the FEED & CUT procedure is not completed when replacing the
: 20 % - 60 % RH