Draining The Unit; Direct Drainage; Installing The Filter - EdgeStar AP16000G Owner's Manual

Draining the Unit

When the portable air conditioner is in cooling mode or dehumidify mode, it will remove moisture
from the air. The condensed water from the air will be collected in an internal reservoir and will be
evaporated and exhausted out of the exhaust hose. However, in very humid conditions, the
internal reservoir may fill completely. This causes the air conditioner to turn off to avoid
overflowing the internal reservoir. When the water tank is full a buzzer will sound eight times and
the LED window will display the error code "H8".

Direct Drainage

1. Remove the rubber drain plug from the drain port.
2. Connect a drain hose to the drain port.
The portable air conditioner will now drain through the drain hose.
Please note that this unit has no drain pump; all water will drain with gravity only, i.e., only
"downhill."

Installing the Filter

Your portable air conditioner ships with a carbon filter to help remove any unwanted odor from the
room. It is recommended you replace the filter every two to three months, or as needed. It is also
necessary to clean the pre-filter periodically (see page 16 for maintenance instructions). Follow
the steps below to install the carbon filter:
1. Shut off the unit if it is on. In the rear of the unit pull the air filter grille from the side.
2. Place the carbon filter between the grille and the pre-filter.
3. Close the grille.
10