Surface Mounting - Raymarine mn100 User Manual

5.4

Surface Mounting

Where there is no access to the rear of the
mounting surface
Easy installation but will allow removal without gaining access to the
boat. Position the supplied Template carefully before starting.
1. Drill three 2.5mm holes marked "B" on the Template.
2. Carefully snap the facia of the display off the main body taking care
not to drop the button pads. .
HINT – It may be useful to place a piece of sticky tape across the
front of the buttons before removing the facia to prevent them from
falling out during the installation.
3. Remove the three captive M4 nuts from the plastic moulding and
attach the display to the mounting surface using the three self
tapping screws provided. Take care not to over tighten the screws as
this may cause the moulding to crack..
4. Check the display is perfectly level, carefully position the button
inserts into the correct slots and snap the facia back into position.
Temporary Mounting
1. Use the double sided tape provided to secure the display to a
suitable mounting surface. Press it firmly against the surface until
secure.
This method is recommended for temporary use only. For
example, finding an appropriate location before drilling holes.
Installation
35