Raymarine mn100 User Manual page 29

S37 Light
S38 LCD Contrast
S39 Boat Show
S40 Factory Reset
SETUP HELTH - Health Chapter
S41 Software Version/Network Nodes
system) then the number of items (nodes) in the system will be
displayed in the lower window. If the display is a "Slave" (was switched
on by the system) then the signal strength to the "Master" will be shown.
Tells the display to control the system Backlighting or just its
own Backlighting.
The options are: Network/Local.
Allows the contrast of the LCD display to be adjusted to suit
the viewing angle of the display. The lower the figure the less
contrast is visible.
The available options are: 1 - 7 default 4.
Allows the display to show information when NOT installed
as part of a Micronet system for demonstration purposes
only.
Displays will return to default Off on power down.
Returns all the calibration setting to the factory default values
but does not reset your Auto Networking.
Only carry out a Reset after consulting with an authorized
Raymarine dealer.
The upper window shows the display's Software Version.
The lower window shows battery level and charge rate, by
means of the appropriate icons, to assist in troubleshooting
and fault finding.
If the display is the "Master" (the one used to switch on the
Set-up and Calibration
27