Table of Contents
Advertisement
368 Wheels and tires
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
page 363)
→
R
Restarting the tire pressure monitoring sys‐
tem
Requirements
The recommended tire pressure is correctly
R
set for the respective operating condition on
each of the four wheels (
→
Restart the tire pressure monitoring system in
the following situations:
The tire pressure has changed.
R
The wheels or tires have been changed or
R
newly fitted.
On-board computer:
Service
Tires
,
.
Swipe downwards on the Touch Control on
#
the left-hand side of the steering wheel.
The
Use Current Pressures as New Refer-
ence Values
message is shown in the multi‐
function display.
Press a to confirm the restart.
#
The
Run Flat Indicator Restarted
shown in the multifunction display.
Current warning messages are deleted and
the h yellow warning lamp goes out.
After you have driven for a few minutes, the
system checks whether the current tire pres‐
sures are within the specified range. The cur‐
rent tire pressures are then accepted as ref‐
page 363).
erence values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R
Radio equipment approval of the tire pres‐
sure monitoring system
message is
Radio equipment approval numbers
Country
Canada
page 363)
→
Radio type approval number
IC: 2546A-GG4;
IC: 2546A- MC34MA4;
Le présent appareil est conforme
aux CNR d'Industrie Canada
applicables aux appareils radio
exempts de licence. L'exploita‐
tion est autorisée aux deux con‐
ditions suivantes:
(1) l'appareil ne doit pas produire
de brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
Advertisement
Table of Contents
