Wet Vacuum Operation - Vacmaster vmvK1650SWdc User Manual

Coal, magnESIum, graIn or gun poWDEr. To rEDuCE THE rISK of HEalTH
HazarDS from VaporS or DuST, Do noT VaCuum ToXIC maTErIalS.
WARNING: Do noT plug In poWEr CorD To poWEr ouTlET. maKE SurE
plug IS DISConnECTED bEforE CHangIng anD ClEanIng fIlTErS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. In order to prepare your vacuum for dry vacuuming, verify that the PET cartridge
filter is securely mounted.Make sure the filter is pushed in until it stops against the
power head. (fig.2) (Your Wet/Dry Vac comes ready with the cartridge filter pre-
installed, if not see page 16 for installation instructions.)
3. Place filter retainer on top of PET cartridge filter and tighten down by turning the
retainer handle clockwise. (fig.3)
4. Put the PRE cloth filter over the filter tray with the attached PET cartridge filter.
(fig.4)
5. Optional, for improved dust filtering, fit collection bag flange onto the inlet stub,
taking care not to damage the bag. (fig.5)
6. Place the power head back on the container, and secure it in place
using the latches. (fig.6)
 
OPERAtING INStRUctIONS: Dry VaCuumIng
7. Insert the locking end of the hose into the vacuum port and screw in place. Push
the required attachment onto the free end of the hose or extension. (fig.7)
8. Plug in the power cord into the outlet. (fig.8)
9. Turn the motor on by flipping the switch to the 'I' ON position. (fig.9)
10. Once you have completed vacuuming, flip the switch to the 'O' OFF position and
unplug the power cord from the outlet.
0 = OFF
Do noT uSE CollECTIon bag for lIQuID VaCuumIng
I = ON
1 2
5 6
9
W
Et-vAcUUm OPERAtION
WARNING: bE SurE To rEaD, unDErSTanD, anD apply InformaTIon,
EnTITlED 'SafETy InSTruCTIonS & WarnIngS'. Do noT VaCuum In
arEaS WITH flammablE gaSES, VaporS, or EXploSIVE DuSTS In THE aIr.
flammablE gaSES or VaporS InCluDE buT arE noT lImITED To; lIgHTEr
fluID, SolVEnT TypE ClEanErS, oIl-baSE paInTS, gaSolInE, alCoHol or
aEroSol SprayS. EXploSIVE DuSTS InCluDE buT arE noT lImITED To;
Coal, magnESIum, graIn or gun poWDEr. To rEDuCE THE rISK of HEalTH
HazarDS from VaporS or DuST, Do noT VaCuum ToXIC maTErIalS.
WARNING: Do noT plug In poWEr CorD To poWEr ouTlET. maKE SurE
plug IS DISConnECTED bEforE CHangIng anD ClEanIng fIlTErS.
Do noT uSE THE CarTrIDgE fIlTEr for lIQuID VaCuumIng.
Do noT uSE CollECTIon bag for lIQuID VaCuumIng.
opEraTIng InSTruCTIonS – WET VaCuumIng
1. Verify that the power cord is disconnected from the outlet. (fig.1) Make sure that
the container is clean and free from dust and dirt.
2. Remove collection bag, cartridge filter & PRE cloth filter, then carefully install the
3 4
7 8