Break-In - TOHATSU MFS 9.9E Owner's Manual

]ENOM00033-A

4. Break-In

Your new outboard motor and lower unit
require break-in for the moving compo-
n e n t s a c c o r d i n g t o t h e c o n d i t i o n s
described in the following time table.
Please refer to ENGINE OPERATION sec-
tion (See page 32) to learn how to cor-
rectly start and operate the outboard
motor.
ENOW00024-A
DANGER
Do not operate the outboard motor in
closed area or area with no forced ventila-
tion.
Exhaust gas emitted by this outboard
motor contains carbon monoxide that will
cause death if inhaled continuously. Inhal-
ing the gas initially causes symptoms such
as feeling of sickness, drowsiness and
headache.
During operation of the outboard motor:
1–10 min
Throttle Position
Speed
10 min – 2 hrs
Less than 1/2
Idle
throttle
Approx. 3000
-1
min (rpm) max
PRE-OPERATING PREPARATIONS
Keep peripheral area well ventilated.
Always attempt to stay on the windward
side of emission.
ENOW00023-1
CAUTION
Operating the outboard motor without
break-in can shorten service life.
If any abnormality is experienced during
the break-in:
Discontinue the operation immediately.
Have the dealer check the product and
take proper action(s) if necessary.
ENON00008-0
Note
Proper break-in allows outboard motor to
deliver it full performance for longer service
life.
2–3 hrs 3–10 hrs
Less than 3/4
3/4 throttle
throttle
Approx. 4000
-1
Full throttle run min (rpm). Full
allowed for 1 throttle run
min every 10 min allowed for 2
min every 10 min
29
6
After 10 hrs
Full throttle
available